Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
2. Initial High Pressure Rinse
The next step is to spray the cleaning
surface with water to clear off any dirt or
grime that may have collected on the
surface. This will allow your detergent to
attack the deep down dirt that has worked
its way into the cleaning surface. Before
triggering the gun, adjust the nozzle to a
wide fan pattern and slowly adjust to the
desired spray pattern. This will help you
avoid applying too much concentrated
spray to the surface which could cause
damage.
3. Detergent Application
USE THE INSTRUCTIONS
APPROPRIATE FOR MODEL
PURCHASED
NOTE:
Use only detergents formulated for
pressure washes.
NOTE:
Test detergent in an inconspicuous
area before use.
Figure 7- Detergent application
Units with Detergent Applicator
Included
Follow manufacturer's label directions for
mixing correct concentrations of detergent
to water ratio through the pressure washer
is approximately 5.4% (1 to 19).
1. Unscrew to top of detergent applicator
and fill applicator with detergent.
2. Replace top on applicator.
3. Remove lance from gun.
4. Attach detergent applicator to gun. ( See
Figure 8)
5. Apply detergent so it thoroughly covers
cleaning surface. Apply from bottom to top
12
Publicité
