Télécharger Imprimer la page

Kenwood MG510 Mode D'emploi page 8

Masquer les pouces Voir aussi pour MG510:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
All manuals and user guides at all-guides.com
kebbe maker
s
shaper*
cone*
t
* Stored in the pusher
Kebbe is a traditional Middle Eastern
dish: deep-fried lamb-and-bulgur-
wheat parcels with a minced meat
filling.
to use the kebbe maker
1 Release the locking screw by turning
anticlockwise ¹, then slide the
attachment into the outlet
2 Turn it both ways until it locks into
place. Then turn the locking screw
clockwise to secure.
3 Fit the scroll inside the mincer body.
4 Fit the shaper
over the pin.
5 Fit the cone
6 Screw the ring nut on.
7 Fit the tray.
8 Switch on. Using the pusher, gently
push your mixture through. Cut into
lengths.
stuffed kebbe recipe
outer casing
500g (1lb 2oz) lamb or fat-free
mutton, cut into strips
500g (1lb 2oz) bulgur wheat,
washed and drained
1 small onion, finely chopped
Important
Always use the bulgur wheat straight
away after draining. If it is allowed to
dry out, it may increase the load on
the mincer resulting in damage.
1 Using the fine screen, mince
alternate batches of meat and
wheat.
2 Mix. Then mince twice more.
3 Stir the onion into the mix.
4 Push through, using the kebbe
maker (see above).
.
– put the notch
.
Filling
400g (10oz) lamb, cut into strips
15ml (1tbsp) oil
2 medium onions, finely chopped
5-10ml (1-2tsp) ground allspice
15ml (1tbsp) plain flour
salt and pepper
1 Using the fine screen, mince the
lamb.
2 Fry the onions until golden brown.
Add the lamb.
3 Add the remaining ingredients and
cook for 1-2 minutes.
4 Drain off any excess fat and allow to
cool.
To finish
1 Push the casing mixture through,
using the kebbe maker.
2 Cut into 8cm (3") lengths.
3 Pinch one end of the tube to seal it.
Push some filling – not too much –
into the other end, then seal.
4 Deep fry in hot (190˚) oil for about 6
minutes or until golden brown.
care and cleaning
power unit
Wipe with a damp cloth, then dry.
mincer attachment
1 Loosen the ring nut manually or with
the spanner
all the parts in hot soapy water, then
dry. Don't wash any part in the
dishwasher. Never use a soda
solution.
2 Re-assemble.
3 Wipe the screens with vegetable oil,
then wrap in greaseproof paper to
prevent discolouring/rusting.
4 If you keep the mincer on the
machine, put the dish/cover on the
tray as a dust-cover.
5 You can pull the lid off the pusher
and store the sausage and kebbe
attachments inside.
6
and dismantle. Wash

Publicité

loading