Publicité
Les langues disponibles
Les langues disponibles
The front part of the base plate has a V-groove that allows
for chamfering edges.
1. Select the desired cutting depth on the knob (6);
2. Position the V-groove on the edge that you want to
chamfer;
3. Press the lock-on button (8) and the "ON/OFF" switch (7)
simultaneously;
If you do not press the lock-on button, the "ON/OFF" switch
remains locked.
4. Let the blade reach maximum speed;
5. Push the planer towards the workpiece continuously;
6. To switch off the planer lift it off from the workpiece
surface and release the "ON/OFF" switch.
Before chamfering the edge of the workpiece, carry
out a depth test on the edge of a piece of wood.
Before performing cleaning, adjusting, repairing and
maintenance work, switch the appliance off and unplug the
power cord. Wait for the blade to stop completely.
The electric planer does not require any additional
lubrication or maintenance. However, you must perform
regular cleaning for a continuous and trouble-free
operation.
Always keep blades clean and sharp. Properly cared blades
jam less frequently, are more easily controlled, and allow
greater efficiency during operation of the appliance.
Keep the roller and blade clean to ensure accurate cutting.
The motor will not start if the carbon brushes are worn out.
The brushes must be replaced in time, otherwise there will
be poor contact between the brushes and the rotor, which
may lead to sparks and damage to the power tool. The two
brushes should be replaced at the same time by two
brushes with equal characteristics.
1. Loosen the screws and remove the carbon brush cap
(13);
2. Disconnect the terminals and remove the worn-out
brushes;
3. Place the new carbon brushes and connect the
terminals;
4. Fit the carbon brushes cap and tighten the fixing screws.
Always ensure that the appliance is switched off and the
power cord is disconnected before removing the dust and
shavings collection bag.
1. Remove the collection bag;
2. Empty the bag. Shake it to shake off dust and other
debris;
3. Put it back on the planer.
Wear a dust mask and protective goggles when
emptying the collection bag.
The blades can be sharpened on a bench grinder or a
sharpening stone. If there is too much unevenness or wear,
you should use a bench grinder before you use a
sharpening stone.
1. Place the sharpening stone for 2 or 3 minutes before
sharpening the blades;
2. Sharpen the blades on a bench grinder with a fine grit
grinding wheel;
3. After sharpening the blade on the grinding wheel, use
the sharpening blade to achieve a finer finish and edge.
Ensure that the blades, at the end of the sharpening
operation, have the same length and angle.
Publicité
