Publicité
Les langues disponibles
Les langues disponibles
▪ Never use the planer on metal parts or wood parts with
nails, screws or other metal objects. Remove metal
objects from the workpiece before using the planer;
▪ Do not apply too much pressure on the planer against
the work piece/object, the weight of the planer applies
enough pressure. If the speed drops abruptly, you
should reduce the pressure applied immediately;
▪ Move the planer steadily during operation;
▪ Always use sharp blades in good condition. Replace
damaged or bent blades immediately;
▪ Never switch the planer on when the blade is in contact
the workpiece. Do not touch the blade to the workpiece
until it has reached its maximum rotation speed;
▪ Do not use the planer if there are cloths, fabrics, wires or
similar objects in the work area;
▪ Do not tilt the planer, thus avoiding unwanted planing
marks;
▪ Run the planer in the direction of wood grain;
▪ After switching off the planer, the roller will continue to
rotate for a short period. Never put the planer down
before the roller has come to a full stop.
The cutting depth can be adjusted between 0 - 3 mm.
1. Turn the cutting depth adjustment knob (6) to the
required depth. The arrow on the base of the adjustment
knob indicates the depth selected on the scale (5).
At the beginning of work, always select a small
cutting depth and test on the workpiece. Repeat the
procedure until the desired depth is reached.
The parallel guide is used to ensure that thinning is carried
out parallel to the end (edge) of the workpiece. The cutting
width can be set between 0 - 82 mm.
1. Loosen the parallel guide fixing bolt (12);
2. Adjust the guide to the required cutting width. The
cutting width value is indicated by the edge of the
parallel guide bracket (2) on the scale (11);
3. Tighten the fixing bolt.
The rebate depth guide ensures that when the planer is in
operation the intended depth is not surpassed. The notch
depth can be set between 0 - 18 mm.
1. Loosen the fixing bolt of the rebate depth guide (16);
2. Adjust the accessory according to the desired depth. The
cutting depth value is indicated by the arrow;
3. Tighten the fixing bolt.
1. Position the front part of the base plate onto the
workpiece;
2. Press the lock-on button (8) and the "ON/OFF" switch (7)
simultaneously;
If you do not press the lock-on button, the "ON/OFF"
switch remains locked.
3. Let the blade reach maximum speed;
4. Move the planer towards the workpiece continuously and
smoothly, always with the parallel guide (1) against the
edge of the workpiece;
5. To switch off the planer lift it off from the workpiece
surface and release the "ON/OFF" switch.
Ensure that the blades do not contact the workpiece
before starting the planer.
Publicité
