Publicité
Les langues disponibles
Les langues disponibles
Always wear protective gloves when changing
blades.
The blades should always be sharpened or replaced
at the same time. Otherwise, the appliance will
become unbalanced which will cause vibrations and
decrease the electric planer's lifespan.
1. Lay the planer with the base plate (3) facing upwards;
2. Turn the roller until the bolts of one of the blades are
visible;
3. Loosen and remove the blade fixing bolts;
4. Press the blade guard (15) and slide the blade retaining
plate outwards;
5. Remove the blade and sharpen it;
6. Set the blade position on the adjustment screws
according to the wear on the blade. This guarantees the
cutting depth defined in the technical data of the planer;
7. Attach the blade to the roller. Align the holes of the
blade and adjustment screw with the groove and the
holes of the roller respectively;
8. Fit the blade fixing plate and tighten the screws;
9. Turn the roller 180° and repeat the procedure for the
other blade.
After the blade's installation and before using the
power tool, test it at full speed at no load for a while.
Check for misalignment of the blade or any other condition
that may affect the power tool's operation. Check that all
moving parts rotate smoothly, without abnormal noises.
1. Fit the parallel guide (1) into the fixing bracket (2);
2. Insert and tighten the parallel guide fixing bolt (12);
3. Fix the parallel guide bracket to the planer and tighten
the bracket's fixing bolt (4).
The parallel guide can be installed on both sides of
the planer.
1. Fit the rebate depth guide accessory (17) to the planer;
2. Insert and tighten the fixing bolt (16) of the rebate depth
guide.
The rebate depth guide must be installed on the right
side of the planer.
Use the dust and shavings collection bag to keep the work
surface clean.
1. Fit the collection bag to the dust and shavings outlet
port (15).
Never attempt to remove the collection bag or any
object that is obstructing while the blades are
rotating.
The power tool is designed for planing wood materials
(such as beams and boards), make notches or chamfering
edges.
While operating the planer, you should take into
consideration some procedures:
▪ Always ensure that the planer is switched off before
plugging in the power cord and during transport. If you
have the "ON/OFF" switch pressed when connecting the
power cord or carrying the planer, accidents and injuries
to the user may occur;
▪ Never hold a workpiece with your hands or use your legs
as a support while you are working. Secure the
workpiece on a stable and completely stationary surface;
▪ Hold the appliance with both hands, one on the handle
and the other on the depth adjustment knob;
▪ Ensure that the blade guard is always fitted;
▪ Make sure there are no obstructions on the surface to be
worked on;
Publicité
