Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
1- STEAM IRONING
Filling the water tank
- Unplug your iron before filling it.
- Set the steam control on DRY (A).
- Open the water tank filler cover completely (B), set the iron on a table (not when the iron is
hot) shown in the diagram (C) below, and fill the tank.
- Do not exceed the MAX line indicated on the water tank (with the iron set on its heel).
- Close the water tank filler cover.
A
Setting the temperature
- Set the temperature control shown in the diagram below (D) referring to the table
below (or on the heel).
- The thermostat light comes on.Wait for the light to go off and come on again before
you start ironing (E).
Setting the steam level (F)
- In order to avoid water dripping from the iron onto the
linen:
• Turn off the steam when ironing silk or synthetic fabrics.
• Set it at the minimum position for wool.
What temperature and which steam setting to use ?
FABRIC
THERMOSTAT CURSOR
LINEN
COTTON
WOOL
SILK
SYNTHETIC
Polyester, Acetate,
Acrylic, Nylon
Moistening the linen (Spray)
- When steam or dry ironing, press several times on the
Spray Button to moisten the linen (G) and to remove
stubborn creases.
- Make sure that there is water in the tank before using
this button.
G
Recommendations:
Fabrics and ironing temperatures:
• Your iron heats up quickly: begin by ironing those fabrics that are ironed at low
temperatures, then go on to those requiring a higher temperature;
• If you turn down the thermostat, wait until the thermostat light comes back on
before beginning to iron again.
• When ironing fabrics with mixed fibres, set the ironing temperature for the most
delicate of the fibres.
B
D
POSITION OF
MAX
●●●
●●
●
●
C
E
F
STEAM SETTING
POSITION
MAX
MIN
DRY
= STEAM ZONE
Publicité
