Publicité
F E AT U R E S - O P E R AT I O N S
Final Assembly
1. Slide the inner extension pole (M) up from the lower
outer pole (O), first loosening the height adjustment
collar (N). To securely hold this position, tighten the
height adjustment collar (N).
2. Place the fan head assembly into this extension pole,
inserting the fan's head neck into the pole opening.
Lock the neck into the extension pole by using the
locking screw and nut (L) and secure tightly.
OPERATING INSTRUCTIONS
1. Set fan base on a dry, level surface.
2. Plug cord into any standard 120 volt AC outlet.
Please make sure the Speed Control Knob is in the
OFF (O) position. Speed Control Knob (H) is located
on the Fan Motor Housing.
3. The SPEED is adjusted by turning the Speed Control
Knob (H) to the desired setting, O-1-2-3.
4. The OSCILLATION control knob (I) is located on the
top of the Fan Motor Housing. To start Oscillation,
push Control knob down. To stop Oscillation, pull
Speed Control Knob up.
ADJUSTMENT INSTRUCTIONS
Tilt-Adjustment
Follow these instructions to tilt the Fan Head for upward
angle air movement.
1. To change the tilting angle of the fan head, simply
loosen the tilt-adjustment knob (K).
2. Move the fan head to the desired angle and firmly
tighten the tilt-adjustment knob to lock into place.
All manuals and user guides at all-guides.com
Height Adjustment
Follow these instructions to adjust the height of the fan.
1. While holding the inner extension pole (M) with one
2. Adjust the pole to the desired height and firmly
CLEANING/MAINTENANCE INSTRUCTIONS
Follow these instructions to correctly and safely care for
your fan. Please remember:
FAN CLEANING
• Always unplug the fan before cleaning or
• Do not allow water to drip on or into the fan motor
• Do not use any of the following as a cleaner:
Fan Blade Cleaning
1. To access the fan blade, remove the front grill and
2. Clean the fan blade, front and rear grills with a soft,
3. Replace blade, tighten securing screw and securely
Fan Head, Base and Pole Cleaning
Using a soft, moist cloth, with or without a mild soap
solution, carefully clean the fan base, pole and head.
Please use caution around the motor housing area. Do
not allow the motor or other electrical components to be
exposed to water.
hand, turn the height adjustment collar (N) counter-
clockwise to loosen the pole.
tighten the height adjustment collar in a clockwise
direction.
disassembling.
housing.
gasoline, thinner, benzine.
securing screw.
moist cloth.
fasten the front grill (see detailed instructions in the
Fan Head Assembly section).
Publicité
