Publicité
F E AT U R E S - O P E R AT I O N S
ASSEMBLY INSTRUCTIONS
Assembly Time: 10-15 minutes.
Tools Required: Phillips head screw driver.
NOTE: MAKE SURE YOU REMOVE ALL CONTENTS FROM
THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR
PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN.
Base/Pole Assembly
You will need the base (P), lower outer pole (O), and
L-shaped locking lever (Q).
1. Insert the threaded end of the L-shaped locking lever
into the hole through the base cover.
2. While holding the base cover with one hand vertically,
connect the outer pole to the base, sliding the
L-shaped locking lever into the bottom of the outer
pole with your other hand.
Fig. 1
C
D E
B
A
S
A. Logo Plate
B. Front Grill
C. Grill Clips (6)
D. Fan Blade
E. Rear Grill Securing Screw
and Nut
F. Rear Grill
G. Motor Shaft
H. Speed Control Knob
I. Oscillation Knob
J. Motor Housing
K. Tilt Adjustment Knob
L. Locking Screw and Nut
M. Inner Extension Pole
N. Height Adjustment Collar
O. Lower Outer Pole
P. Base
Q. L-Shaped Locking Lever
All manuals and user guides at all-guides.com
F
G
H I
J
K
R
L
M
N
O
P
Q
R. Blade Securing
Screw
S. Grill Screw and Nut
3. Turn the L-shaped locking lever clockwise to securely
attach the pole to the base.
4. Set the base on the floor.
Fan Head Assembly
You are now ready to assemble the fan head.
1. Loosen the Rear Grill Securing Screw and Nut (E)
from the motor housing. Position the rear grill (F)
over the motor shaft (G), making certain that the 2
guiding posts at top of the rear grill centre aligns
with the 2 top holes on the outer ring of the motor
housing (J). First insert the 2 guilding posts into the 2
holes at top and pull down the 2 slots to lock in
place. Then align the bottom screw post onto the
bottom hole and replace the rear grill securing screw
and nut (E) and tighten the screw.
Guiding
Posts
E
2. Loosen the blade securing screw (R) on side of the
fan blade (D) to slide the fan blade onto the motor
shaft (G) through the rear protrusion. Make sure the
blade securing screw (R) rest on the notch (flat side)
of motor shaft and tighten the screw (R).
CAUTION: Avoid contact with sharp end of blades.
3. Remove the grill screw and nut located on the bottom
of the grill.
4. Centre the front grill (B) by aligning the Bionaire
logo on the logo plate so that it is horizontal and
parallel with the floor. Then place the bracket at the
top over the front and rear grills with the hole on the
bracket going through the center vertical bar. Fasten
the other clips, making sure they go over both the
front and rear grills.
5. Replace grill screw and nut (S) and tighten with screw
driver.
®
Publicité
