Cuckoo CBT-I1030RW Mode D'emploi page 21

Basic method of use
Sit on the seat.
Sit in the center of the toilet
seat to activate the sensor.
Press the button.
Press the DRYER button to
begin drying.
The bidet will carry out the function for 3 minutes
before automatically shutting off.
The seating sensor of this product is installed inside the seat.
It activates as soon as your skin comes in contact with the seat at the location of the seating sensor. If a cover, etc. is
applied over the surface of the seat, the skin will not touch the seat, which may not activate the seating sensor.
SIMPLE CONTROL PANEL ON THE MAIN FRAME
• The simple control panel can activate basic functions (CLEAN/STOP) in the
case that the remote control is lost, broken, or the batteries have been
depleted.
• Due to its limited functions, the temperature control and water pressure
cannot be adjusted using the simple control panel.
Sit on the seat.
Sit on the center of the
toilet seat.
Press the button.
Press the desired button to
initiate the cleaning function.
If the button that was pressed during use is pressed
one more time, MOVE CLEAN can be used.
The initiated function
will stop.
Press the CLEAN button.
CLEAN function can be used.
After cleaning, the bidet
will automatically begin the DRYER
function for 3 minutes then shut off.
If the button that was pressed
during CLEAN is pressed one
more time, MOVE CLEAN can
be used.
HOW TO USE
or
Press the STOP
button.
Simple
Control Panel
Press the STOP button.
CLEAN or DRYER operation stops.
21