Klarstein 10012127 Mode D'emploi page 18

EN
18
All manuals and user guides at all-guides.com
• In order to avoid overheating, do not cover or obstruct the heater in any way.
• Overheating will result if it is accidentally covered.
• Never immerse the product in water or any other liquids.
• Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
• Do not use the appliance outdoors.
• Do not use if you have wet hands.
• Never use the appliance on or near hot surfaces.
• Before cleaning the appliance, ensure it is unplugged from the power and that it is
completely cooled.
• Do not clean the appliance with abrasive chemicals.
• Never use accessories that are not recommended or supplied by the manufacturer.
It could cause danger to the user or damage to the appliance.
• Do not lift the appliance by the front panel.
• In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
Note: This heater is not equipped with a device to control the room temperature. Do
not use this heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
INSTALLATION
• The fire must not be used until it is securely fastened to the wall.
• Do not connect the appliance to the mains until properly fixed to the wall and the
instructions are read fully.
• The minimum distances must be observed in the diagrams below.
• For installation of the appliance, care must be taken not to damage concealed
cables.
• Please be careful whilst drilling holes.
Note: This appliance is designed to be permanently fixed to a wall at a minimum
height of 300 mm.The wall bracket must be fitted horizontally and the cable routed to
the bottom right of the heater.