koban KDP1 Mode D'emploi page 77

and each segment can cover 30o
detection area. For example, to install
the detector at the height of 2.5m,
the detection range can reach up
to 1m diameter if the complete lens
shield has been used; and up to 4m
diameter if the A+B layers of lens
shield has been used; and up to 6m
diameter if only the A layer of lens
shield has been used (See FIG.23).
After user choosing the desired
detection area, the redundant lens
The whole lens shield is used.
A & B layer of the lens shield is used.
www.grupotemper.com
All manuals and user guides at all-guides.com
A
B
C
KDP1 360 FP
Presence detector
shield should be eliminated. The
shadow part of lens shield in FIG.23
refers to the cut-off part.
Fixing lens shield: There is circular
hook on the back of the decorative
frame and the lens shield is designed
with a circular groove. The lens shield
can be fitted by joining the groove
of lens shield with its corresponding
hook on the decorative frame (See
FIG.24).
Instructions manual |
Φ 1m
Φ 4m
77