POWER SMITH MAGLITHION MLMS12C Manuel De L'opérateur page 8

OPERATiON
WARNiNG:
To reduce the risk of serious personal injuries, read and follow
all important safety warning and instructions before using this tool.
WARNiNG:
Always disconnect battery pack from tool or place the switch
in the locked or off position before any assembly, adjustments or changing
accessories.
ATTACHING SANDPAPER, SCRUBBING PAD (NOT INCLUDED) AND
POLISHING PAD (NOT INCLUDED)
The sander comes with a Hook and Loop Quick attaching pad. Align the pointed tip and rounded edge
of this sandpaper or a pad with the pointed tip and rounded edge of the Hook and Loop pad. Carefully
press the fuzzy side of the sandpaper against the pad as tightly as possible.
NOTE
: Sandpaper can be reused for the life of the sanding abrasive. it is
recommended that you keep the sandpaper backing pad clean to provide for the
best adhesion. Clean occasionally by brushing backing sandpaper lightly with a
small brush.
To remove sandpapers and pads, simply pull the used sandpaper off the Hook & Loop base
and attach the desired sandpaper by pressing it onto the base of the sander.
SWITCH ACTION
CAUTiON
: Before insertion of battery pack, always check to see that the tool is
switched off.
The switch can be locked in "ON" position for ease of operator comfort during extended use. Apply
caution when locking tool in "ON" position and maintain a firm grasp on the tool. Your sander is equipped
with a flexible plastic boot that covers the "ON/OFF" switch; this is referred to as a "dust-protected
switch". It is not uncommon for sanders to collect large amounts of airborne sawdust in the switch area,
which, if not cleared out, may cause the switch to become non-functional. The dust protected switch, on
the other hand, can not accumulate dust in the switch area.
To start the sander, press down the "I" (ON) side of the switch.
To stop the tool, press down the "O" (OFF) side of the switch.
OPERATING
WARNiNG:
Read and understand safety and operating instructions of
designated battery and charger before using this tool. This manual contains
important safety and operating instruction for the battery charger.
• Insert the battery pack.
• Secure the work piece by clamp or other device to prevent it from moving under the sander.
• Grasp sander tightly in front and away from you; keep it clear of the work piece. Turn on sander and
let motor build to its maximum speed. Slowly lower the sander onto the work piece. Move the sander
slowly across the work piece using small circular motions.
English
All manuals and user guides at all-guides.com
8