Dometic RH418NTE Instructions De Montage Et De Service page 17

RH418NTE, RH418NTEG
• The minimum clearance between the cooling device's back and the surrounding
structure should be as follows:
No. in
fig. a, page 6
2
3
• The ventilation duct must at least measure 105 mm x the width of the cooling
device.
• The entire cooling unit must project into the ventilation duct as shown.
• Air passing through the ventilation duct must not be preheated by any source of
heat.
• The ventilation duct must be kept free from any obstacles. Especially portable
multi socket outlets or portable power supplies, which can get warm, must not
be kept at the rear of the cooling device.
➤ Fix the cooling device through its fixing feet as shown (fig. b, page 7).
5.4 Mounting the sliding hinge (optional)
You can mount a sliding hinge that allows the cooling device door to be opened at
the same time as the door of the built-in cabinet.
➤ Mount the sliding hinge as shown (fig. c, page 7 to fig. f, page 8).
6 Operation
6.1 Before first use
Before first use, clean the minibar inside and outside with a damp cloth for hygienic
reasons (see also chapter "Cleaning and maintenance" on page 20).
6.2 Saving energy
• Only open the minibar as often and for as long as necessary.
• Avoid unnecessarily low temperature settings.
• For optimal energy consumption, position the shelves and drawers according to
their position on delivery.
EN
Min. distance
20 mm
105 mm
Operation
17