Maintenance And Cleaning - WIKA switch GAUGE PGS10 Mode D'emploi

7. Commissioning, operation / 8. Maintenance and cleaning
Permissible vibration load at the installation site
The instruments should always be installed in locations free from
„
GB
vibration.
If the pipe to the gauge is not rigid enough for a vibration-free
„
installation, the gauge should be mounted by means of mounting
devices for surface or pipe mounting, and, if necessary, with a capillary.
If necessary, it is possible to isolate the instrument from the mounting
„
point by installing a flexible connection line between the measuring
point and the pressure gauge and mounting the instrument on a suitable
bracket.
If this is not possible, the following limit values must not be exceeded:
„
Frequency range < 150 Hz
Acceleration < 0.5 g (5 m/s
Commissioning
During the commissioning process pressure surges must be avoided at all
costs. Open the shut-off valves slowly.

8. Maintenance and cleaning

8.1 Maintenance
The instruments are maintenance-free.
„
The indicator and switching function should be checked once or twice
„
every year. The gauge must be disconnected from the process to check
with a pressure testing device.
Repairs are only to be carried out by the manufacturer or appropriately
„
trained skilled personnel.
14
WIKA operating instructions models PGS10, PGS11 and PGS21
)
2