Echelon EX-7S Manuel D'instructions page 15

Place seat onto seat post and secure
with included wrench.
Insert handlebar post bolt into
hole on post. Use small hex key
to tighten. Ensure handlebar post
is fully inserted before inserting
handlebar post bolt.
Pull the wires out of frame and the
wires from base of handlebar post.
Connect the wires from frame and
handlebar post together, then feed
excess wire down into frame.
Screw in handlebar height
adjustment lever until you feel slight
resistance. You will adjust this later
before your first ride.
Fully insert handlebar post into
frame until the hole at the bottom
of handlbar post aligns with hole in
frame for the handlebar post bolt.
Untie the twist tie at top of
handlebar post, ensuring not to
allow the wires to fall inside of
handlebar post. Connect the wires
from the handlebar post to the wires
at bottom of screen mount.
15
1