Husqvarna K 535i Manuel D'utilisation page 13

CAUTION: Do not use diamond blades with
positive rake angles.
CAUTION: Do not use diamond blades with
greater gap between segments than max 10
mm (A).
A
CAUTION: Do not use diamond blades with
greater blade thickness than recommended
maximum, refer to
23 .
CAUTION: Some cutting situations and
worn blades may cause increased wear on
the side of the segments. Replace the blade
before it is worn out.
To examine the spindle shaft and
flange washers
Examine the flange washers and the spindle shaft when
the blade is replaced.
CAUTION: Use only flange washers
supplied by Husqvarna with minimum
diameter 60 mm/2.4 in.
CAUTION: Do not use damaged, defective
or dirty flange washers.
745 - 008 - 12.11.2018
Technical data on page
CAUTION: Do not use different dimensions
of flange washers.
• Make sure that the threads on the spindle shaft are
not damaged.
• Make sure that the surfaces on the blade and the
flange washers are not damaged, of the correct
dimension, clean, and that they run correctly on the
spindle shaft.
To examine the arbor bushing
• Use only Husqvarna arbor bushings.
• Make sure that the arbor bushing has the correct
dimension for the cutting blade. The correct
dimension is printed on the cutting blade.
To attach the cutting blade
1. The cutting blade is put on the bushing (A) between
the inner flange washer (B) and the flange washer
(C). The flange washer is turned to attach to the
axle.
B
A
C
13