Publicité
Les langues disponibles
Les langues disponibles
MAXIMUM / MINIMUM MEMORY FOR UVI
To view the maximum and minimum memory for UVI:
1. Press SELECT to navigate to the Barometer Area.
2. Press MODE to select the UV display.
3. Press MEM to show maximum, minimum and
current UVI readings.
4. Press and hold MEM for 2 seconds to clear the
UVI memory.
NOTE The UV sensor must be activated before you try and
set the additional features.
TEMPERATURE AND HUMIDITY
The weather station can display the following information
from any of the 5 remote sensors:
•
Current,
minimum,
and
and relative humidity percentages.
•
Comfort level indicator and trend line (rising,
falling, or steady).
Data is collected and displayed approximately every
60 seconds.
VIEW TEMPERATURE AND HUMIDITY AREA
Press SELECT to navigate to the Temperature and Humidity
Areas.
Temperature data is given at the top; Humidity is below.
SELECT MEASUREMENT UNIT
Slide the °C / °F switch (inside the clock battery
compartment), to the setting you want.
All manuals and user guides at all-guides.com
maximum
temperatures
SELECT SENSOR CHANNEL
Press CHANNEL to switch between sensors 1-5.
•
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will
be displayed for 3 seconds.
•
To end auto-scan, press CHANNEL or MEM
with the Temperature / Humidity Area selected.
NOTE If you select a sensor that collects only temperature
data, the humidity will not be shown.
MINIMUM / MAXIMUM RECORDS
•
Press
MEM
maximum and minimum records for the selected
sensor.
•
To
clear
the
for 2 seconds. A beep will sound to confirm that
the memory has been cleared.
TEMPERATURE AND HUMIDITY TREND
The trend lines are shown next to the temperature and
humidity readings.
TREND
RISING
TEMPERATURE
HUMIDITY
16
repeatedly
to
view
records,
press
and
hold
STEADY
FALLING
current,
MEM
Publicité
