ENERMAX ERV1250EGT Manuel D'utilisateur page 6

NAME OF PARTS
920/1020W
Output cable: Please check "Cables & Connectors" section.
# 1
Fan
Honeycomb air vent
ON/OFF switch (I=ON, O=OFF)
#3
CordGuard
# 2
AC Inlet
PowerGuard LED
#1 To ensure best system cooling, do not block PSU fan's air in-take and air vent area.
This PSU offers a special HeatGuard function. When the system is turned off, or goes into ACPI
S3/S4 sleep mode, the PSU fan will keep dissipating the remaining heat for 30 ~ 60 seconds and
prolonging system lifetime.
#2 When assembling or maintaining the system, please remove AC cord from AC inlet, or turn
ON/OFF switch into "OFF" position.
#3 AC cord can get loose in many ways. The ENERMAX CordGuard lock can fix your AC cord
tightly to the PSU, so that it will not be easily detached and avoid shut-downs of your PC. The
following is CordGuard installation:
Set your PSU into the chassis, and please
make sure the I/O switch is on "O"
position.
Plug the AC cord into your PSU.
1. CordGuard is for AC cords supplied with ENERMAX CordGuard-compatible PSUs. Other AC
cords may be incompatible.
2. When assembling or maintaining the system, please remove AC cord from AC inlet, or turn I/O
switch into "O" position.
1250W
# 1
# 2
4
Press two sides of the CordGuard lock
together, and set it into CordGuard holder
near the AC inlet.
Lock CordGuard to latch onto AC cord.
ENGLISH