Pentair UltraTemp-E Serie Guide De L'installation page 12

Operating the Heat Pump
The pool pump must be on and water flowing through the heat pump for it to operate.
With any new pool or spa installation, operate the filter pump with the heat pump off long enough to completely
clean the water. This will remove any installation residue from the water. Clean the filter at the end of this
operation before starting the heat pump. When raising the temperature of a cold pool, program the time clock to
run the pump continuously. This lets the filter system and heat pump operate continuously until the water reaches
the temperature setting on the temperature control. When that happens, the heat pump will automatically shut
off, but the filter pump will keep running.
Swimming Pool Energy Saving Tips
Heat Pump Control Panel Overview
ON/OFF
MENU SELECT
POOL/SPA
UP and DOWN Arrow
LCD SCREEN
ON Light
SERVICE Light
ATTENTION - INITIAL START UP PRECAUTIONS