Panasonic ER-GB40 Instructions page 9

Clean
Cleaning the trimmer
It is recommended to clean at every use.
1. Remove the trimmer from the AC adaptor.
▼
To remove light dirt
2. Remove the comb
attachment and turn the
trimmer on.
3. Run water down the water
inlet at the back of the main
body, rinse thoroughly for
approximately 20 seconds,
and then turn the trimmer
off.
• Rinse with water and
shake up and down
several times to remove
the water.
▼
4. Wipe off the water with a towel and let it
dry naturally.
• It will dry faster with the blade removed.
5. Apply the oil to the blade after drying.
6. Attach the comb attachment and blade
to the trimmer.
ER-GB40_EU.indb 7
All manuals and user guides at all-guides.com
▼
For heavy dirt
2. Remove the comb
attachment and blade.
3. Clean the trimmer and the
blade with running water.
• Rinse with water and
shake up and down
several times to remove
the water.
▼
4
Cleaning with the brush
1. Remove the trimmer from the
AC adaptor.
• Make sure that the trimmer is
turned off.
2. Remove the comb attachment.
3. Hold the main body, place your
thumb against the blades and
then push them away from the
main body.
4. Brush off any hair trimmings from the
main body and from around the blade.
5. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down the
cleaning lever to raise the moving blade.
6. Apply the oil to the blade.
7. Attach the comb attachment and blade to the trimmer.
7
2012/06/14 13:21:10