Publicité
Les langues disponibles
Les langues disponibles
Operation Button Panel
There are three buttons and temperature display window on the control
panel, let you operate your unit and reach your desired running way.
Temperature Adjustment
Press two buttons "
" &"
desired value. Each pressing, the temperature will change 1 Fahrenheit.
Setting Range: 32-50 Fahrenheit. The default setting is 39 Fahrenheit.
Interior Light Control
The unit has built-in with the LED light in the cooling compartment. The
internal LED light is controlled
by the magnetic door switch and the light button "
panel. Normally, when you open the door, The LED light will be on, again
close the door, the LED light will be off at once. But if you press the "
button for more than 3 seconds, it will cut the supply power to the LED
light,
opening or closing the door will not activate the LED light. Only pressing
the "
" button for more than 3 seconds again to cancel this lock, will
the LED light recover to be on or off with the door opening and closing.
Note: Wait 3-5 minutes before restarting if you unplug the refrigerator.
The unit may fail to operate properly if restarted too quickly.
10
" to adjust the set temperature to your
" on the control
HOW TO CLEAN
Cleaners: Never use harsh, abrasive cleaners, heavy-duty cleaners, or
solvents on any surface.
Exterior: Wipe with a damp, sudsy cloth, rinse and dry. For stubborn
stains and for periodic waxing, use silicon wax.
Refrigeration Section: Wash shelves and other removable parts in warm
sudsy water, rinse and dry. Wash interior with baking soda solution (3
tablespoons to 1 liter of water) or warm sudsy water, rinse, and dry.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to
desired setting.
HOW TO INSTALL
This appliance can either stand alone or be built in. The front grille
must be not obstructed.
• Install the unit in a convenient location away from extreme heat and
cold. This unit should be far away from the heating source, such as
stoves, heaters, or radiators, and is prevented from direct sunlight. Allow
"
sufficient clearance between the unit and sidewall so the door will open
without obstruction. This refrigerator is designed for recessed or built-in
installation.
• Place the unit on a level surface that will be strong enough to support
the unit when it is fully loaded. Not recommended for carpeting or other
soft / uneven surfaces. To level your fridge, adjust the front feet located at
the bottom of the unit.
• For under-counter built-in installation, please following the follow
diagram, and leave the enough space for the unit.
11
Publicité
