SIGNIFY LIGHTOLIER LWWH Serie Mode D'emploi page 2

Signify Classified - Internal
IS:LWWH20/LWWH40
INSTRUCTIONS FOR INSTALLING LOUVER 81LV4 :
1. Turn off power to TRACK.
2. First insert BOTTOM SPRINGS on the LOUVER into the BOTTOM GROOVE in the luminaire (Fig. 6 & 7)
3. While pushing down TOP SPRING TABS, rotate LOUVER toward the TOP GROOVE in the luminaire until it hits the FRONT STEP on
the luminaire. Release the TOP SPRING TABS into the TOP GROOVE (Fig. 6, 7 & 8).
4. To remove, push down the TOP SPRING TABS and rotate away from the luminaire (Fig. 7).
NOTE: Ensure that all four LOUVERS SPRINGS are fully engaged for safe operation (Fig. 8).
TOP SPRINGS
BOTTOM
SPRINGS
SPRING TAB
Fig. 6
INSTRUCTIONS FOR INSTALLING OPERATIONG VISOR 81VZ4:
1. Place LONG TAB of visor in GROOVE. (Fig. 10 )
2. Rotate VISOR toward Luminaire.
3. Press SUPPORT BEAM enough to engage SHORT TABS into GROOVE. (Fig. 9)
4. Ensure both LONG AND SHORT TABS are engaged in GROOVES in Luminaire. (Fig. 9)
5. TO REMOVE: Press down on SUPPORT BEAM of VISOR and pull VISOR away from Luminaire.
SUPPORT
BEAM
LUMINAIRE
VISOR
Fig. 10
Rotate in directions as shown (Fig. 12)
Horizontal and vertical rotation have mechanical stops.
DO NOT force past stops.
1/28/2019 page 2
www.lightolier.com
TOP
SPRINGS
BOTTOM
SPRINGS
Fig. 7
Fig. 11
FINAL POSITION OF VISOR
LyteSpan BoldFlood
Fig. 8
FINAL LOUVER POSITION
SHORT
TABS
SHORT
Fig. 9
TABS
HORIZONTAL
ROTATION
Fig. 12
GROOVE
GROOVE
VERTICAL
ROTATION