Uline H-5737 Mode D'emploi page 2

3. Insert 5/16 x 5½" long hex head lag screw, with fender
washer, into leg support and tighten until secure.
(See Figure 3)
NOTE: DO NOT overtighten screw.
Figure 3
4. Repeat step 3 for remaining three corners.
5. Insert spill pallet at an angle between sidewalls with
fork pockets facing outwards. Press firmly down until
secured in the grooves on both sidewalls. Place
grate(s) onto spill pallet. (See Figure 4)
Figure 4
Fork Pockets
PAGE 2 OF 6
ASSEMBLY CONTINUED
Spill
Pallet
Grates
1-800-295-5510
6. Insert top brace into space provided on sidewalls.
(See Figure 5)
7. Fasten top brace to sidewalls with 5/16-18 x 2" cap
screws and fender washers. (See Figure 5)
WARNING: DO NOT overtighten screw.
Figure 5
8. Ease doors into grooves on sidewalls. Start with
door with aluminum on one edge. Push door until it
is securely inserted into grooves on both sidewalls.
Repeat for door without aluminum edge. Make sure
the second door slides under the first. (See Figure 6)
Figure 6
uline.com
Top
Brace
0622 IH-5737