Télécharger Imprimer la page

AGA MARVEL 6CRDE Instructions D'installation, D'utilisation Et D'entretien page 6

Publicité

Les langues disponibles

Les langues disponibles

Step by step instructions for locating the po-
sition of the bracket:
1) Decide where you want to place the drawer refrigerator.
Slide it into place, being careful not to damage the floor,
leaving 1"(2.5cm) of clearance from the rear wall to allow
room for the anti-tip bracket.
2) Raise the rear leveling legs approximately
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the refrigerator is in the desired location, then
mark on the floor the rear and side corner of the cabinet
where the anti-tip bracket will be installed. If the installation
does not allow marking the rear corner of the cabinet, then
make temporary lines on the floor marking the front corner
of the cabinet, excluding the door. Slide the refrigerator out
of the way. From the temporary line extend the sidewall line
back 21
(55.6cm) as shown in Figure 7.
7
8
4) Align the anti-tip bracket to the marks on the floor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21
" (55.6cm) line (Rear of cabinet
7
8
line).
5) Fasten the anti-tip bracket to the floor using the supplied
screw. (See Figure 7).
6) Slide the cabinet back into position, making sure the rear
cabinet leveling leg slides under the anti-tip bracket engag-
ing the slot.
21
"
7
8
(55.6cm)
Figure 7
All manuals and user guides at all-guides.com
INSTALLING THE ANTI-TIP DEVICE
" (6.4mm) to
1
4
Rear Leveling leg
"V" notches
in bracket
One of the rear cabinet leveling legs must be engaged
under an anti-tip bracket.
If floor mounting of the bracket is not possible call AGA
Marvel service at (800-223-3900) for optional wall mount
bracket part number 42245874. The wall mount bracket
requires 1
"(4.8cm)
7
8
behind the rear of the cabinet for mounting.
Screw
6
"V" notches
in bracket

Publicité

loading