Télécharger Imprimer la page

Tecfrigo WINE 32 Installation Mode D'emploi Et Entretien page 8

Publicité

Les langues disponibles

Les langues disponibles

Thank you for purchasing your new wine cooler. Please note that these instructions apply to all
wine coolers in the Compact wine range. Illustrations and fittings may therefore not necessarily
correspond exactly to your model.
Warning
In case this appliance contains hydrocarbon (R600a) refrigerant please refer to guidelines
listed below. These are not relevant to R134a (HCFC). Please check rating plate placed on the
back of the appliance for type of refrigerant.
WARNING: - keep ventilation openings, in the appliance enclosure or in the built-in structure,
clear of obstruction.
WARNING: - do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
WARNING: - do not damage the refrigerant system.
WARNING: - do not use electrical applian-ces inside the refrigerated storage compartments,
unless they are of a type recommended by the manufacturer.
WARNING: Do not expose the appliance to rain.
* Always keep the keys in a separate place and out of reach of children.
* Before servicing or cleaning the appliance, unplug it from the mains.
As the appliance contains a refrigerant which is flammable (Isobutane R600a) it is essential to
ensure that the refrigerant pipes are not damaged. If damage does occur, avoid sparks or
naked flame in the vicinity of the appliance, ensure that the room is well ventilated, disconnect
the power supply, and contact your supplier. The unit must only be serviced by qualified
technicians from an approved service centre.
Old appliances
Old refrigerators and freezers are often fitted with complicated latches that can only be opened
from the outside. If you have one of these old units stored away somewhere, or if you scrap
one, remember to destroy the latch first in order to prevent children from being exposed to
great danger by getting locked inside the unit.
Before use
Before operating your new appliance, please read the following instructions carefully as they
contain important information on safety, installation, operation and maintenance. Keep the
instructions for future reference. On receipt, check to ensure that the appliance has not been
damaged during transport. Transport damage should be reported to the local distributor before
the wine cooler is put into use.
Remove the packaging. Clean the inside of the cabinet using warm water with a mild detergent.
Rinse with clean water and dry thoroughly (see cleaning instructions). Use a soft cloth. If the
appliance has been laid down during transport, or if it has been stored in cold surroundings
(colder than +5°C), it must stabilise in an upright position for at least one hour before being
switched on.
Installation and start-up
Placement
For safety and operational reasons, the appliance must not be installed outdoors. The
appliance should be placed on a level surface in a dry, well ventilated room (max. 75% relative
air humidity). Never place the appliance close to sources of heat such as cookers or radiators,
and avoid placing it in direct sunlight.
Room temperature
The climate class is stated on the rating plate. This specifies the optimum room temperature.
Installation
The surface on which the appliance is to be placed must be level. Do not use a frame or
similar. It is important that the appliance be absolutely level.
Tecf
8

Publicité

loading