Télécharger Imprimer la page

Tecfrigo WINE 32 Installation Mode D'emploi Et Entretien page 11

Publicité

Les langues disponibles

Les langues disponibles

Never use sharp or pointed implements. Avoid unnecessary cleaning of the wooden shelves,
as these are made of untreated natural material. Cleaning agents may discolour the shelves.
The sealing strip around the door must be cleaned regularly to prevent discolouration and
prolong service life. Use clean water. After cleaning the sealing strip, check that it continues to
provide a tight seal. Dust collecting on the condenser underneath the cabinet, on the
compressor and in the compressor compartment is best removed using a vacuum cleaner.
Replacing the lighting
Light-emitting diodes designed to last the entire service life of the appliance are used. If it,
however, becomes necessary to replace the light source, please call for service.
Removing the shelves 32-45
Position the shelf with the carving opposite the pin "A", see figure 9. It is now possible to lift up
and pull out the shelf.
Removing the shelves 38
Push the shelf all the way back and tip it. It is now possible to remove the shelf.
LED LIGHT
In order to reduce energy consumption, this wine cabinet will automatically switch off the LED
lights after 10 minutes.
If you want the LED light to remain on continuously, this is possible. Please press and hold the
"LIGHT" button for 5 seconds, the display will show "LP". After 4 seconds, the display will revert
to normal and the light will remain on until manually switched off.
If you want to revert and conserve energy (recommended), please press and hold the "LIGHT"
button for 5 seconds, the display will show "LF". After 4 seconds, the display will revert to
normal, and the light will automatically switch off after 10 minutes.
Our products are for internal use only do not install outside restaurants, shops.
rigo
11

Publicité

loading