Publicité
Les langues disponibles
Les langues disponibles
4.
After cleaning, thoroughly oil the foam filter with 30 or
40 weight motor oil and squeeze out any excess oil before
reinstalling it. Make sure to press the foam filter evenly
into place over the filter reinforcement plate to ensure
that the foam is fully seated into its sealed position.
5.
Replace the air filter cover so that it fully snaps into place
and is secured by the latch tab. Check that the cover is
securely attached by pulling slightly on the cover. If the
cover doesn't move when pulled, it is secure.
WARNING
DO NOT SIPHON FUEL BY MOUTH. GASOLINE IS TOXIC
AND CAN CAUSE INJURY TO PERSONNEL.
NEVER STORE CULTIVATOR WITH FUEL IN THE FUEL TANK
INSIDE AN ENCLOSED AREA OR BUILDING. FUEL VAPORS
CAN COLLECT AND CAUSE A FIRE.
TRANSPORTING YOUR CULTIVATOR
1.
After using the cultivator and before transporting it,
screw the gas cap on (clockwise) tightly. The gas cap will
not leak during transporting if gas cap is tight. Never
transport engine inside an enclosed space within a
vehicle. Fuel or fuel vapors may ignite causing serious
injury or death.
2.
If fuel is present in the fuel tank, transport in an open
vehicle in an upright position.
3.
If an enclosed vehicle must be used, remove gas into an
approved red fuel container. DO NOT siphon by mouth.
4.
Run engine to use up the fuel in the carburetor and fuel
tank. Always run engine in a well ventilated area.
5.
Wipe away any spilled fuel from engine and cultivator.
Allow to dry.
6.
Gas cap should be turned down tightly before
transporting cultivator in a vehicle.
LONG-TERM STORAGE
If your cultivator will not be used for more than one month,
prepare it for long term storage.
16
Get parts online at www.tazzoutdoorproducts.com or Call 800-345-6007 M-F 8-4:30 CST
LATCH TAB
LATCH TAB
RETAINER
COVER PIVOT
POINT
AIR FILTER
BASE
Owner's Manual
2-CYCLE CULTIVATOR
FIGURE 11
FILTER
REINFORCEMENT
PLATE
FOAM FILTER
ELEMENT
AIR FILTER
COVER
FIGURE 12
Publicité
