Publicité
Les langues disponibles
Les langues disponibles
UNPACKING AND ASSEMBLY
CARTON CONTENTS
CULTIVATOR ASSEMBLY
•
Hardware Parts Bag:
•
A - (4) Three-Knob Nut
•
B - (4) Curved Washer
•
C - (4) Saddle Bolt
•
Manual Parts Bag
•
Left Middle, Right Middle, and U-Turn™ Handlebars
•
"A" and "B" Tine Sets
•
Bottle of 2-cycle Engine Oil
NOTICE
HANDLE CULTIVATOR WITH CARE. DO NOT DAMAGE CABLE
WHEN TRANSPORTING OR OPERATING.
WARNING
COMBUSTIBLE DEBRIS CAN CATCH FIRE. IT IS A VIOLATION
OF CALIFORNIA PUBLIC RESOURCE CODE, SECTION 4442,
TO USE OR OPERATE ENGINE-POWERED PRODUCTS ON
ANY FOREST-COVERED, BRUSH-COVERED, OR GRASS-
COVERED LAND UNLESS THE EXHAUST SYSTEM IS
EQUIPPED WITH A SPARK ARRESTER, AS DEFINED IN
SECTION 4442, MAINTAINED IN EFFECTIVE WORKING
ORDER. OTHER STATES OR FEDERAL JURISDICTIONS
MAY HAVE SIMILAR LAWS. CONTACT THE ORIGINAL
EQUIPMENT MANUFACTURER, RETAILER, OR DEALER TO
OBTAIN A SPARK ARRESTER DESIGNED FOR USE WITH THIS
PRODUCT.
ASSEMBLY
1.
Stand the tiller cultivator assembly upright with tines and
wheels on a level surface. Wheels should be set in the
lowest position. DO NOT place the tiller cultivator on a
high surface where it can fall and cause property damage
or personal injury.
2.
Using two three-knob nuts, two saddle bolts, and two
curved washers, attach the middle handlebars to the
lower handlebar that is already connected to the tiller
cultivator assembly. The middle handlebars can be
installed in one of two positions, one high and one low.
DO NOT overtighten the three-knob nuts. SEE FIGURE 2.
10
Get parts online at www.tazzoutdoorproducts.com or Call 800-345-6007 M-F 8-4:30 CST
U-TURN™
HANDLEBAR
THREE-KNOB
NUT
RIGHT
MIDDLE
HANDLEBAR
FIGURE 2
DRAG
STAKE
FIGURE 3
Owner's Manual
2-CYCLE CULTIVATOR
CURVED
WASHER
SADDLE BOLT
LEFT MIDDLE
HANDLEBAR
LOW POSITION
MOUNT HOLES
HIGH POSITION
MOUNT HOLES
LOWER
HANDLEBAR
LOCK PIN
Publicité
