Publicité
Les langues disponibles
Les langues disponibles
2.
Keep all screws, nuts, and bolts tight.
3.
For cold weather operation, store the unit in a cool
environment. Transferring the unit from a cold to a warm
place can cause the build up of harmful condensation.
ENGINE MAINTENANCE
Refer to engine emission warranty included with your product
for maintenance schedule.
Good maintenance is essential for safe, economical, and
trouble-free operation. It will also help reduce air pollution.
To help you properly care for your engine, the following
pages include routine inspection procedures, and simple
maintenance procedures using basic hand tools. Other service
tasks that are more difficult, or require special tools, are best
handled by professionals and are normally performed by a
technician or other qualified mechanic.
Maintenance, replacement or repair of the emissions control
devices and systems may be performed by any non-road
engine repair establishment or individuals. However, items
must be serviced by an authorized dealer to obtain "no
charge" emissions control service.
The maintenance schedule applies to normal operating
conditions. If you operate your engine under unusual
conditions, such as sustained high-load or high-temperature
operation, or use in unusually wet or dusty conditions, consult
your servicing dealer for recommendations applicable to your
individual needs and use.
SPARK PLUG
The recommended spark plug is a Torch L8RTC which cross
references to a Champion RCJ6Y.
1.
Check spark plug at the beginning of each season.
UPPER
GREASE PORT
LOWER
GREASE PORT
FIGURE 10
Get parts online at www.tazzoutdoorproducts.com or Call 800-345-6007 M-F 8-4:30 CST
2.
Disconnect the spark plug cap, and clean any debris from
around the spark plug area.
3.
Remove spark plug and replace if any of the following
occur; pitted electrodes, burned electrodes, cracked
porcelain, or deposits around electrodes.
4.
After analysis, seat spark plug and tighten with spark plug
wrench. Reconnect the spark plug wire.
•
Reinstall original spark plug, tighten additional
1/2 turn.
•
Installing new spark plug, adjust spark plug gap to
0.028" and tighten additional 1/8 – 1/4 turn.
NOTE: Loose spark plug may overheat and damage
engine. Over tightened spark plug may damage
threads in the cylinder head.
COOLING FINS
Cooling fins, air inlets and linkages must be free from any
debris before each use.
CARBURETOR
Never tamper with factory setting of the carburetor.
CAUTION
DO NOT TWIST AIR FILTERS WHEN CLEANING. ALWAYS
PRESS. TWISTING OR TOO MUCH FORCE CAN DAMAGE THE
FILTER ELEMENT.
AIR FILTER
Never run engine without air cleaner properly installed. Added
wear and engine failure may occur if air cleaner is not installed
on engine.
Service air cleaner every 3 months or after 20 hours of
operation. Clean filter daily in extremely dusty conditions.
To Replace or Clean Air filter, do as follows:
1.
Before removing the air filter cover, move the choke lever
to the CHOKE position. SEE FIGURE 5.
2.
To remove air filter cover, squeeze the latch tab and rotate
about cover pivot point to remove from air filter base. SEE
FIGURE 11.
3.
Remove the foam filter element and reinforcement
plate. Replace with a new oiled foam filter or clean the
original foam filter with warm water and mild soap. SEE
FIGURE 12.
Owner's Manual
2-CYCLE CULTIVATOR
15
Publicité
