Greenway Pro Serie Instructions D'installation Et Manuel Du Propriétaire page 9

C. Drain Clamp Installation
Choose the drain outlet location per, page 7.
The following are instructions for discharging into the sink drain pipe. (Refer to Fig. 1, page 5.)
Position the Drain Clamp on the sink drain pipe above the drain trap. Allow room for drilling. Tighten securely.
1.
2. Use a battery pow ered or properly grounded drill. Using the Clamp port as a drill guide, drill a 7/32" hole
through the wall of the drain pipe. Do NOT penetrate the opposite side of the pipe.
Locate the 3/8" Black Drain Tubing which is shipped loose in the box.
3.
NOTE: When cutting the polytubing make clean, square cuts, failing to do so could result in poor connections and
possible leaks.
CAUTION: The lowest point of the line should be the point of connection to the Drain Clamp. There should be no sag
in the line as this may cause excessive noise as the reject water is flowing to drain. Firmly press one end of the tubing
over the 3/8" drain outlet hose barb on the Dispensing Faucet. Allow the tubing to relax, then press firmly again to
insure proper seating. No connectors are required when attaching hose to Hose Barbs. Route the tubing to the Drain
Clamp and trim to length.
• Refer to Fig. 4, below. Insert the tubing into the Drain Clamp. Make sure the tubing is pressed all the way in to
create a pressure-tight connection.
NOTE: If you want to pull the tubing out for some reason, push the ring around the tubing in and pull the tubing out.
All manuals and user guides at all-guides.com
3/8" Drain Clamp Assembly
9