Publicité
Les langues disponibles
Les langues disponibles
3.
Assemble and attach the Faucet (refer to Fig. 2 right).
•
Assemble the Body and Spout by removing the plastic shipping plug
from the Body and then firmly pressing in the Spout.
•
In the following order, place the Face Plate (Escutcheon) on the 7/16"
stud.
•
From the top of the counter place the stud through the mounting hole.
•
From the bottom of the counter top, in the following order, assemble
the Slotted Washer, the Plastic Spacer (with open end upwards), the 7/16"
Washer and the 7/16" Hex Nut.
•
To the end of the 7/16" stud screw on the 3/8" Polytube Quick
Connect Fitting. Once snug by hand take a pair of pliers and tighten the
fitting an additional half turn. Don't over tighten.
•
Rotate the Spout and Body into position. Align the Slotted Washer and
the Spacer to allow access to the Hose Barbs, and tighten the Hex Nut while
holding the faucet in alignment with a padded Crescent wrench.
Do not over tighten.
B.
Feed Water Saddle Valve Installation
Decide on location. Do NOT connect to a hot water feed line. If you are not
sure of the supply, run the hot water and feel the supply piping.
Water over 100°F may cause permanent damage to the R.O. Membrane.
(Refer to Fig. 3 below.)
Shut off the water supply and drain the line.
1.
2a.
To install on (soft) Copper Tubing supply line:
•
Turn the Handle of the Feed Water Saddle Valve counter clockwise (outward) until the lance does not protrude
from the gasket. It may have to be pushed in.
•
Assemble the Feed Water Saddle Valve on the tubing.
–for 3/8" OD tubing use the back plate side with the small groove to prevent distortion of the tubing.
–for larger tubing (up to 5/8" OD) use the large groove of the back plate.
•
Assemble and tighten the brass screw.
•
To pierce the tubing, turn the Valve Handle fully clock wise (inward). A small amount of water may escape from
the outlet until it is fully pierced.
•
When you feel the Valve Handle firmly seated in the clockwise direction, the copper tube is pierced and the
valve is closed.
2b.
To install on (hard) Steel or Brass Tubing supply line.
All manuals and user guides at all-guides.com
• The supply line should now be drained. Use a battery
powered or properly grounded drill to avoid shock hazard.
• Drill a 3/16" hole in the supply line; (do not drill through the
opposite wall).
• Turn the handle to expose the lance no more than 3/16"
beyond the rubber gasket.
• Place the body of the valve over the hole so that the lance fits
into the hole.
• Assemble and tighten the brass screw.
• Turn the Valve Handle clockwise (inward) until firmly seated.
The valve is closed.
3. With the Feed Water Saddle Valve closed, open the sink
faucet and the water supply and allow the water to run for a few
minutes to flush any debris caused by the installation.
• Close the faucet and check the Feed Water Saddle Valve for
leaks.
8
Long Reach Air Gap Faucet With 3/8" Connector
Publicité
