Publicité
Les langues disponibles
Les langues disponibles
WARNING:
ELECTRICAL REQUIREMENT - SHOCK HAZARD
Electrical Requirement
• Make sure there is a suitable power outlet (115 volts, 15 amps
outlet) with proper grounding to power the Countertop Refrigerator.
• Avoid the use of three prong adapters or cutting off the third
grounding prong in order to accommodate a two prong outlet. This is
a dangerous practice since it provides no effective grounding for the
beverage cooler and may result in shock hazard.
Installation Limitations
• Do not install your beverage cooler in any location not properly
insulated or heated (e.g., garage etc.). Your beverage cooler was
not designed to operate in ambient temperature settings below 55˚
F/12.8℃.
• Select a suitable location for the beverage cooler on a hard even
surface away from direct sunlight or heat source (e.g.,radiators,
baseboard heaters, cooking appliances, etc.). Any floor unevenness
should be corrected with the leveling legs located on the front and
rear bottom corners of the beverage cooler.
• Your beverage cooler is designed for freestanding installation only.
It is not designed for built-in application.
Note: This unit is for indoor use only.
Use of Extension Cord
• Avoid the use of an extension cord because of potential safety
hazards under certain conditions.If it is necessary to use an
extension cord, use only a 3-wire extension cord that has a 3-blade
grounding plug and a 3-slot outlet that will accept the plug. The
marked rating of the extension cord must be equal to or greater than
the electrical rating of the appliance.
Shelving (See Fig. #2)
To remove or replace a full-width slide-out shelf:
1. Gently tilt the shelf up and slide forward until the shelf has been
completely removed.
2. To replace the shelf, gently slide the shelf back.
06
Fig. #2
Normal Operating Sounds You May Hear
• Boiling water, gurgling sounds or slight vibrations that are the result
of the refrigerant circulating through the cooling coils.
• Compressor makes operational sounds when cycling on and off.
Proper Care & Cleaning
Cleaning and Maintenance
Warning
To avoid electric shock, always unplug before cleaning. Ignoring this
warning may result in death or injury.
Caution
Before using cleaning products, always read and follow
manufacturer's instructions and warnings to avoid personal injury or
product damage.
General
• Prepare a cleaning solution of 3-4 tablespoons of baking soda
mixed with warm water. Use sponge or soft cloth, dampened with
the cleaning solution. To wipe down your beverage cooler, rinse with
clean warm water and dry with a soft cloth.
• Do not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. Some of
these chemicals may dissolve, damage and/or discolor your
beverage cooler.
07
Publicité
