Costway EP23231 Mode D'emploi page 3

7) If your old beverage cooler is not being used, we recommend that
you remove the doors and leave the shelves in place. This will
reduce the possibility of danger to children.
8) This beverage cooler should not be recessed or built-in in an
enclosed cabinet. It is designed for freestanding installation only.
9) Do not operate your beverage cooler in the presence of
explosive fumes.
10) Your beverage cooler was NOT designed to store perishable
foods. Store only bottled or canned beverages.
SAVE THESE INSTRUCTIONS
DANGER
Risk of child entrapment. Before you throw away your old appliance,
take off the doors. Leave the shelves in place so that children may
not easily climb inside.
Parts and Features
1. Wire Shelf
2. Tinted Double Pane Glass Door
3. Adjustable Leveling Legs
4. Drip Tray in Back (not shown)
04
Installment
Unpacking Your beverage cooler
1. Remove all packaging material. This includes the foam base and
all adhesive tape holding the beverage cooler accessories inside
and outside.
2. Inspect and remove any remaining packing, tape or printed
materials before powering on the beverage cooler.
Leveling Your beverage cooler
• Your beverage cooler has two leveling legs which are located in the
front corners. After properly placing your beverage cooler in its firm
position, you can level your beverage cooler.
• Leveling legs can be adjusted by turning them clockwise to lower
your beverage cooler or by turning them counterclockwise to raise
your beverage cooler.The beverage cooler door will close more
easily when the two front leveling legs are extended slightly.
Proper Air Circulation
• To ensure that your beverage cooler works at the maximum
efficiency it was designed for, you should install it in a location where
there is proper air circulation and electrical connections.
• The following are recommended clearances around the beverage
cooler:
Sides...............2" (50mm)
Top....................2" (50mm)
Back..................2" (50mm)
• Do not over fill your beverage cooler for proper cooling.
Note: If your beverage cooler has been tilted for any reason, wait 24
hours before plugging it in.
Drip Tray
• Ensure the drip tray in the rear of the unit is in the proper position.
05