ECOVACS WINBOT 7 Serie Mode D'emploi page 14

EN
7.3 Squeegee
7.4 Cleaning Driving Treads
7.5 Cupule
7.6 Extension Cord
13
Squeegee maintenance
After each use, gently wipe the Squeegee with a damp cloth to remove residue from
its surface. A wet cloth will allow water to get inside the unit and cause damage to
the internal components. A replacement squeegee may be purchased by going to
our Web Site or calling our service number.
After each use inspect the Treads for possible accumulation of dirt. The total tread
can be inspected by using the remote and pressing the Forward or Reverse arrow.
Clean any dirt with a soft damp pad.
NOTE: Dirty treads can negatively affect the function of the treads driving the
unit on the window.
Cupule maintenance
The Cupule assembly is a basic part of the units function and is located on the
bottom of the unit. After each use, you need to inspect the cupule's surface to
make sure it is not torn or cut. Any debris that is stuck to the surface must be
carefully removed.
Cupule replacement
1. Take the cupule off with a screw driver.
2. Replace it with a new one.
Extension Cord is used to extend Winbot's working range. If your window is too
large, this will be a perfect choose. For the use of Extension Cord, please see the
following picture.
Squeegee replacement
1. Push the Squeegee to the center from each end
of the Squeegee, then take it off.
2. Replace it with a new one: put the new one into
the groove and pull the end of the Squeegee to
each side.