ECOVACS WINBOT 7 Serie Mode D'emploi page 11

4.2 Product Star t
4.3 Product Pause
4.4 Product Stop
Once the unit is attached to the outside of the window, press the Start
●
Button on the unit or the Start/Pause button on the Remote. The
product will use its automatic cleaning mode to clean the window and
return to the start position after having cleaned the window.
NOTE:
This product is intended for cleaning dust on common home windows.
●
WINBOT can NOT be used to clean stains such as painting, glue, etc.
WINBOT can NOT be used to remove items such as chewing gum, label,
papers, etc which may cause suction failure.
Glass with uneven surface, such as frosted, textured, patterned or
●
leaded is not suitable to be cleaned by the WINBOT.
After WINBOT has finished cleaning one window, if the cleaning pads
●
are too dirty, please replace them with a clean set.
The unit may NOT be used outside while raining, snowing or colder than
●
as it will damage the product and could cause electrical
℃ (40℉)
5
problems.
Should the unit stop working and the Indicator Light blink RED, you
●
need to respond by grasping the handle of the unit and turn the switch
OFF. You may then turn the switch back ON and press the Pause/Start
button to start the cleaning process.
If you want to Pause the product during the cleaning process, press the
●
" " button on the Remote Control momentarily or press the "
button on the unit. The product will pause and wait for further
instructions.
While the unit is in the Pause Mode, you may use the Remote to move
●
the unit around the window by pressing the appropriate directional
arrow. This is handy for your use when a spot on the window is difficult
to clean, because you can maneuver the unit back to the spot and clean
again. When you want to return the unit to the Auto Mode to continue
cleaning, press the pause button on the Remote.
If using WINBOT for a long period of time continuously, give yourself
●
and WINBOT a 10 minutes break for every hour of use, this will extend
the life and performance of robot and avoid overheating.
After the product has finished cleaning the window, it will return to the
●
place where you had started the cleaning. If you find the stopping place
is not convenient for you to grasp to remove the unit, use the Remote by
pressing the appropriate directional arrow until the unit is where you can
grasp the handle more conveniently.
Holding the handle of the unit, move the switch to the OFF position, to
●
the far left, and place finger in the Air Release slot and lifting with your
finger, you will release the vacuum from the inner circle. In a few
seconds, the unit will be free from the window.
If you do NOT use the Air Release button, you need to hold the handle
●
for about 45 to 60 seconds. Do NOT try to use the handle as leverage to
pry the unit from the window as you could damage the product.
After removing the unit from the window, do the required maintenance
●
on the product in preparation for storage. BEFORE storing, while the
unit is plugged into your receptacle, move the switch to the Charge
position and allow the battery to charge until the Green light quits
Flashing.
Always Store the unit with the switch in the OFF position.
●
Live Smart. Enjoy Life.
EN
"
10