Problems And Solutions - La Sommeliere CIG251 Notice D'utilisation

Problems and solutions

PROBLEM
Cellar do not operate
Cellar is not cold enough
Hygrometry level is too low
Hygrometry level is too high
The light does not work
Vibrations
The cellar seems to make too much noise
The door will not close properly
LED could not display
LED display error
Bottoms are not functional
POSSIBLE CAUSE
Not plugged in using different voltage. The circuit
breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The cellar does not have the correct clearance.
Check that hygrometry setting on control panel is
correct
Check that tank water is full of water
Check that door is properly closed
Avoid frequent door opening that will affect the
hygrometry stability level.
Check that hygrometry setting on control panel is
correct and lower it to reduce the hygrometry level.
Check the service center.
Check to assure that the refrigerator is level.
The cellar refrigerator is not level.
Check the fan.
The cellar refrigerator is not level.
The doors were reversed and not properly installed.
The seal is weak.
The shaves out of position.
Main control board does not work.
PCB Problem.
There is some problem with the plug.
Weak quality of display.
Temperature point is out off.
Temperature controller panel is damaged.
In case of problem, you must contact your seller.
La Sommelière / FRIO ENTREPRISE
143 Boulevard Pierre Lefaucheux
72230 ARNAGE - France
www.lasommeliere.com
20