Pommier IRIZIUM 500 Mode D'emploi page 6


Technical characteristics
Voltage: 9-36 Volts DC
Maximum commutable current: 9 A
Maximum switchable voltage: 36 Volts DC
Consumption: At rest: 60 mA@12V / 73 mA@24V
Operating: 690 mA@12V / 380 mA@24V
Lighting: 75 Lux @ 2.10m
Luminous flux: 565 Lumen
Delay time: 10 minutes
Please note: The motion sensor initializes during 1 minute the first time it is switched on. The ceiling light
remains on during this phase.
The duration of the first delay is 3 minutes.
Shut-off warning:
Several seconds before the timer expires, the ceiling light will flash 3 times before shutting off.
Working temperature: -30°C to + 50°C
Impact strength index: IK10
Polarised: respect polarity (The product is protected against polarity inversion).
Wiring recommendations (see diagram):
The electrical connection shall be made using a twin cable with a min. cross section of 1.55 mm². To prevent any
electrical hazards, users must ensure the network and the load are protected using a 2A fuse that is fitted upstream.
The ground (0V) shall be connected to the battery and connected to the chassis of the vehicle. The cables shall
preferably be clad onto the chassis.
For the wiring for a single ceiling light with sensor, the unused OUT cables (green/white) will have to be cut
and insulated separately.
Assembly recommendations:
The assembly will be on the vehicle roof calculating approximately 1 m between the detector and the door threshold.
In the case of an assembly on a conductive surface, this surface should preferably be earthed.
Avoid as far as possible the production of electrostatic discharge (e.g. removal of protective film from panels, etc.)
harmful for electrical components.
Guarantee:
Product guaranteed for 3 years in accordance with the special conditions nº DQ-GAR-801
6
/ 12
Waterproof protection rating: IP67
Réf. : 40.52370FT – Doc. N° 5179.800.4(A)