Publicité
3.3 Installing the camera
Firstly, remove the white dome ring by turning it
anti-clockwise.
Loosen the three fastening screws on the dome,
then remove it.
Three through bores for fastening are found on the
outside of the camera base plate.
Hold the base plate as a template on the probable
installation site, mark the three fastening holes on
the surface, then drill the holes. Use the screws
provided to fasten the base plate in place. Cables
can be laid at the side or hidden in the ceiling or
wall.
The camera module can be tilted and rotated along
three axes.
Pan:
Rotation of the complete
camera module
Tilt:
Tilt of the camera module
Rotation: Rotation of the lens with image sensor
and IR PCB (third axis)
IMPORTANT!
The camera must be disconnected from the mains power during installation.
66
Publicité
Chapitres
