VITO VILAPHLV2 Mode D'emploi page 22

1. To turn the laser on, slide the "ON/OFF" switch (5) to the
"ON" position;
2. Slide the "ON/OFF" switch (5) to the "OFF" position.
Never leave the laser on with no one nearby. Always
switch the laser off after each use.
There are three projection modes for the laser lines. When
the laser is switched on, it projects by default the cross-line
pattern mode (360° horizontal and vertical projection) with
self-levelling.
To select the projection mode of the laser beam, press the
laser line selection button (4).
1. Press the button once to select the projection of the
horizontal laser line;
2. Press the button twice to select the projection of the
vertical laser line;
3. If the laser level is in the vertical projection position,
press the projection mode selection button again to
return to the cross-line pattern (horizontal and vertical).
All projection modes can be selected with or without self-
levelling function activated.
Self-levelling:
The self-levelling automatically compensates on uneven
surfaces of ± 4° slope.
The laser level automatically adjusts the levelling whenever
vibrations or position changes have occurred during
operation. After any levelling adjustment, to avoid errors,
you must check the position of the laser beams in relation
to reference points.
If self-levelling cannot be performed because the laser's
base has an inclination greater than 4° to the horizontal,
the self-levelling LED indicator turns red.
If self-levelling range is over ± 4°, the self-levelling function
is disabled.
1. Place the laser on a level, stable surface or fix it on a
stand;
2. Slide the "ON/ON" switch (5) to the "ON" position;
3. Press the laser line selection button (4) according to the
desired laser beam projection mode;
4. Wait until the automatic self-levelling LED indicator (3)
turns green and the projected laser lines are stable. At
this point, the self-levelling laser level is ready for
operation.
Without self-levelling:
When self-levelling is deactivated, the laser lines are
locked but not calibrated and are therefore no longer self-
levelling. You can hold the laser with your hands, place it
on an inclined surface or supports.
1. Slide the "ON/OFF" switch (5) to the "OFF" position;
2. Press the laser line selection button (4) according to the
desired laser beam projection mode;
3. While using the laser without self-levelling function, the
self-levelling LED indicator (3) turns red.
The laser level does
maintenance. However, for a continuous and trouble-free
operation, you must perform regular cleaning and proper
maintenance tasks.
Before carrying out any checking, maintenance or cleaning
work, remove the batteries.
Cleaning
Clean all laser components after each use. Wipe the self-
levelling laser level with a clean, damp cloth or blow it with
low pressure compressed air. Careful handling protects the
product and extends its service life.
Storage
When not in use, store the laser in a dry, clean place, free
of corrosive smoke and out of children's reach. Remove the
battery when storing.
not require any additional