Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
Clean the connectors before disconnecting.
5.
NOTICE: Use quick connectors when installing the ethanol sensor.
6.
Do not use solvents when installing the fuel hose.
7.
Lubricate the quick connector seals with clean engine oil before installation.
2.2.2
Installation of the ethanol sensor
•
Ethanol sensor (Figure F, 1)
•
Ethanol sensor connector (Figure A, 4 / Figure F, 2)
•
Fuel hose and hose clamps (Figure F, 3)
•
Fuel line quick connector (Figure F, 4)
Use quick connectors when installing the ethanol sensor!
The ethanol sensor can be installed to either the incoming fuel pressure line or the return line. Fuel flow direction does not affect the
reading of the sensor. The ethanol sensor should be installed near the fuel rail. We recommend installing the sensor in the incoming
pressure line.
After installing the quick connectors, make sure they are properly locked by pulling the connector back and forth.
I have checked the following before moving on to the next phase
The ethanol sensor is properly fastened with the quick connectors included in the accessories kit.
There are no tight bends in the fuel line.
No solvents were used during the installation.
2.3 Wiring harness installation
The wiring harness installation consist of four steps
1.
Check the engine injector connector polarity with a multimeter. Plug in the male connectors to the wiring harness.
2.
Connect wiring harness to the injectors.
3.
Place the temperature sensor close to the engine block.
4.
Connect the ground wire to a sufficient ground terminal (e.g. battery – terminal).
https://eflexfuel.com/
Publicité
Table des Matières
