Télécharger Imprimer la page

Frico SWH Serie Mode D'emploi page 26

Masquer les pouces Voir aussi pour SWH Serie:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37
Filter
The basic filter should be cleaned when
necessery and checked at least 4 times a year.
To clean the filter, open top or bottom lid by
loosening a pair of screws underneath the lid
and vaccum.
The filter in the filter section is a deep-
pleated bag filter, type EU3 (G85). It should
be replaced when the recommended pressure
drop is increasing 75 Pa. Check the pressure
drop at least 4 times a year.
Pressure drop for deep-pleated bagfilter
replacement: 75 Pa.
Replacement filter of 20 mm frame width:
WxHxD [mm] Number of bags
SWEF1
420x446x350
SWEF2
552x558x400
SWEF3
630x680x450
Damper
Damper with accessories should be checked
reguarly. The damper shaft should be
lubricated when neccesary.
Heating coil
Inspect the coil for water leakage and
corrosion. Dust on the surface of the heating
coil can be vaccumed.
Motor
The motor is normaly maintenanance-free.
If noise or vibrations should occur, inspect
the bearing and replace it if necessary.
Replacement should be carried out by a
certified technician.
Residual current circuit breaker
(applies to units with electric heater)
When the installation is protected by means
of a residual current circuit breaker, which
trips when the appliance is connected,
this may be due to moisture in the heating
element. When an appliance containing a
heater element has not been used for a long
period or stored in a damp environment,
moisture can enter the element.
This should not be seen as a fault, but is
simply rectified by connecting the appliance
to the mains supply via a socket without a
safety cut-out, so that the moisture can be
eliminated from the element. The drying
SWH
time can vary from a few hours to a few days.
As a preventive measure, the unit should
occasionally be run for a short time when it is
not being used for extended periods of time.
Safety
• For all installations of electrically heated
products should a residual current circuit
breaker 300 mA for fire protection be used
• Ensure that the area around the intake is
kept free from material which could
prevent the air flow through the
appliance!
• The appliances have hot surfaces during
operation!
• This product is not designed to be used by
children or persons with reduced physical
4
or mental ability or a lack of experience
4
and knowledge, unless instruction
5
regarding the product's use has been
given by a person with responsibility for
their safety or that this person supervises
operation. Children must be kept under
supervision to ensure they do not play with
the product.
• Lifting aids should be used to lift the
appliance.
• When adjusting the louvers, please notice
that the water heating coil may have sharp
edges.
GB
25

Publicité

loading