Uline H-9940 Mode D'emploi page 2

PHENOLIC TOP INSTALLATION
1. Align drawer frame assembly with pre-drilled holes
in bench top.
2. Attach drawer brackets and spacing bar assembly
at desired location using four blunt-end wood screws
provided with lab workbench top. (See Figure 3)
Figure 3
Wood Screw
3. Remove and discard the spacing bars from
drawer brackets.
DRAWER/HOUSING INSTALLATION
1. Remove the drawer from the housing. Fully extend
drawer from housing and flip one plastic tab on
sliding rails up and second plastic tab down.
Drawer can now be removed. (See Figure 4)
Drawer
Figure 4
PAGE 2 OF 6
INSTALLATION CONTINUED
Tab
1-800-295-5510
2. Align holes at the top of the drawer housing with
holes in drawer brackets. (See Figure 5)
3. Attach drawer housing to drawer brackets using four
Phillips head bolts and four flange nuts. (See Figure 5)
Figure 5
4. Insert drawer and turn packing table upright. Slide
drawer in and out a few times to check operation.
(See Figure 6)
NOTE: Drawer assembly has a 70 lb.
weight capacity.
Figure 6
uline.com
Drawer Bracket
Drawer Housing
0323 IH-9940