Publicité
CD/ RADIO
Finding a passage within a track
1. During playback, press and hold down ∞ or §
y
The CD is played at high speed and low
volume; the display will show 'Cd:' and your
current track number.
2. Release ∞ or § when you recognize the passage
you want.
y
Normal CD playback and standby clock time
resumes.
RADIO
1. Press RADIO ON (FM/ AM) to switch on the
radio.
y
Display shows 'tu' before returning to clock
time.
2. Press RADIO ON (FM/ AM) again if you wish to
change waveband.
3. Adjust the sound using 4 or 3
4. Adjust the TUNING wheel to tune to a radio
station.
To improve reception:
FM: Extend coil antenna at the back of the unit fully
for optimum reception.
AM: Uses a built-in antenna. Direct the antenna by
adjusting the position of your set.
5. Press ALARM RESET to switch off.
SETTING THE ALARM OPTIONS
GENERAL
Two different alarm times, AL 1 and AL 2 can be set
in the CD, radio or buzzer modes.
Selecting the Alarm Mode Options
When selected, the selected alarm mode is shown in
the display, and the respective AL 1 or 2 button
lights up.
1. Select your choice of alarm mode.
Either press briefly:
• AL1 once for CD alarm
playback from the first track as your alarm call.
• AL2 once or more for
buzzer
alarm
/
. This enables CD
radio
SETTING ALARM OPTIONS
Radio Alarm:
If you have selected the radio alarm, make sure
you have tuned properly to a station.
2. Read the following section if you want to select
the WAKE-UP TRACK alarm option.
Selecting CD WAKE-UP Alarm Mode
You can program and select a CD track number
between 1-99, when the set is in the standby or radio
playback mode.
However, if the track number programmed does not
exist on your CD, the CD will start playback from the
first track during the alarm call.
1. Set the alarm time for AL1.
2. Insert a CD into the CD compartment.
3. Press AL 1 to select CD alarm mode.
4. Press WAKE-UP TRACK to activate favorite track
programming.
5. Press ∞ or § until the desired track number is
shown.
6. Press WAKE-UP TRACK to confirm the selected
track number.
y The display returns to standby clock time.
7. If you want to review your programmed track
number, press WAKE-UP TRACK
Note:
• The buzzer alarm option will automatically replace
the CD alarm if you have:
- inserted a CD incorrectly;
- inserted a damaged CD;
- forgotten to insert any CD;
- not closed the CD door properly.
AL TIME 2
Publicité
