Publicité
English
CONTROLS (see figure
1 AL 1 (
ALARM/ OFF)
- selects CD alarm;
- to cancel or switch off CD alarm.
2 WAKE-UP TRACK
- to program to your favorite CD track for wake-up
track alarm option.
3 SLEEP
- adjusts timer options for CD / radio;
- switch on radio for timer mode.
4 REPEAT ALARM/ BRIGHTNESS CONTROL
-changes the brightness of the display window;
-switches off the alarm for a 9 minute period;
-switches off radio / CD timer (SLEEP).
5 Power cord
-connect AC-DC adapter plug to wall outlet.
6 Coil antenna
-antenna to improve FM reception.
7 CD door
- lift here to open / close CD door
8 ALARM RESET (CD/ RADIO OFF)
- stops CD / radio playback;
- switches off radio / CD timer (SLEEP);
- stops the active buzzer, radio or CD alarms for 24
hours.
9 AL 2 (
ALARM/ OFF)
- selects radio
/ buzzer
- to cancel or switch off radio / buzzer alarm.
0 VOLUME 3 , 4
- adjusts the sound level.
! PLAY / PAUSE 2;
- starts / pauses CD playback.
@ DOWN, UP ∞ , §
- adjusts clock / alarm times
- skips CD tracks / searches for a particular passage.
# Tuning indicator
- shows the radio frequency of your selected
waveband.
$ RADIO ON (FM/ AM)
- switches on the radio;
- selects the radio waveband.
1)
alarm mode;
CONTROLS/ INSTALLATION
% TUNING
- tunes to a radio station.
^ TIME/ ALARM
- toggle to set the times for the clock time, or alarm 1
or 2.
& Display
- shows the clock / alarm times and status of the unit.
POWER SUPPLY
1. Check if the power voltage, shown on the AC-DC
adapter plug, corresponds to your local power
supply. If it does not, consult your dealer or service
center.
2. Connect the AC-DC adapter plug to the wall outlet.
3. To disconnect the set completely from the power
supply, withdraw the AC-DC adapter plug from the
wall outlet.
The serial and production number are located on
the bottom of the set.
Standby power consumption (clock mode)..........2W
MEMORY BACKUP
The memory backup conveniently allows your clock and
alarm time settings to be stored for up to 3 minutes when
there is a power interruption e.g. AC power failure.
The complete CD clock radio and lighted display will be
switched off. As soon as the power supply returns, the
display will indicate the correct time.
• If power supply returns after 3 minutes you will need to
re-enter the clock and alarm time settings.
BASIC FEATURES
Display brightness
1. Toggle REPEAT ALARM/ BRIGHTNESS CONTROL.
y The brightness of the display toggles between:
low
bright
Volume
Press 4 or 3 to adjust the
volume level. The volume
level uo: is indicated as a
number from 0-32.
low
Publicité
