Publicité
Les langues disponibles
Les langues disponibles
2. Install two anchor bolts (locally procured: M10 recommended) into the concrete ceil-
ing.
q Install an anchor bolt in the
center of the hole made in the
step 1.
w Determine
the
length by use of Template B
(accessory).
e Use Template B (accessory) to
decide the nut position, and fix
it.
(Mount the nut so that the dis-
tance between the bottom sur-
faces of the nut and ceiling is
adjusted to 134 mm {5-1/4"}.)
Note: If there is already an anchor bolt installed, the anchor bolt can be used as a 2nd anchor
bolt. Make sure that the distance between the 1st and 2nd anchor bolts is 1 000 mm {3.28'}
or less before use.
3. Mount the safety wire angle (accessory) on the 2nd anchor bolt and connect the safe-
ty wire (accessory) to the angle.
q Disconnect the safety wire from the safe-
ty wire angle.
w Engage the face marked q with the
anchor bolt.
e Bend the face marked w.
r Connect the safety wire to the safety wire
angle again.
Note: To use the anchor bolt that was already installed, the use of 2 spacer nuts (locally pro-
cured) is helpful.
All manuals and user guides at all-guides.com
anchor
bolt
Template B
Ceiling board
Spacer nuts
(locally procured)
Safety wire
2nd Anchor bolt
1st Anchor bolt (locally procured)
(locally procured)
Anchor bolt
Install the anchor bolt in the center
of the hole
Anchor bolt
w Insert
q Disconnect
Safety wire
Mark q
Safety wire angle
Nut (locally procured)
Determine the anchor
bolt length
134 mm
{5-1/4"}
Upper side
Mark w
e Bend
Lower
side
r Connect
Spacer nuts
Safety wire angle
Existing anchor bolt
5
Publicité
