BIEMMEDUE SUSETTE Manuel D'instructions page 28

Before using the high pressure washer, carefully read all of the instructions and follow them scrupulously. The
manufacturer cannot be held responsible for damage to persons and/or property caused by improper use of the
equipment.
This instruction manual is an integral part of the equipment and must therefore be stored carefully and passed
on with the unit in the event of a change of ownership.
THE EQUIPMENT MUST BE CONNECTED TO THE POWER GRID THROUGH A CIRCUIT-BREAKER WITH A
•
SENSITIVITY NOT EXCEEDING 30 mA AND FEED FLOW RATE SUITABLE FOR THE POWER OF THE MACHINE
(SEE DATA PLATE)
THE MINIMUM FEEDING FLOW RATE MUST NOT BE LESS THAN INDICATED IN THE PLATE
•
THE FEEDING WATER PRESSURE MUST NOT EXCEED 3 BAR. IF HIGHER, YOU MUST BE PROVIDED WITH
•
SUITABLE PRESSURE REDUCTION VALVE.
APPLIANCE NOT SUITABLE FOR CONNECTION TO THE DRINKING WATER NETWORK: THE PRESSURE
•
WASHER CANNOT
BE CONNECTED DIRECTLY TO THE DRINKING WATER DISTRIBUTION NETWORK WITHOUT HAVING
•
INSTALLED AN ANTI- BACKFLOW DEVICE IN THE SUPPLY PIPE WITH EMPTYING CAPACITY COMPLIANT
WITH CURRENT REGULATIONS. IT IS ALSO NECESSARY TO USE A REINFORCED PIPE WITH A DIAMETER OF
AT LEAST Ø13MM - ½ INCH
WATER PASSING THROUGH ANTI-BACKFLOW DEVICES CANNOT BE CONSIDERED DRINKABLE
•
USE ONLY FILTERED OR CLEAN WATER, PLACING THE PRESSURE WASHER AS CLOSE AS POSSIBLE TO THE
•
WATER SUPPLY NETWORK. THE WATER SUPPLY TAP MUST ALSO GUARANTEE A SUPPLY EQUAL TO TWICE
THE MAXIMUM FLOW RATE OF THE PUMP
EACH TIME THE HIGH PRESSURE WASHER IS USED, AFTER EACH OPERATING CYCLE AND WHENEVER IT IS
•
LEFT UNSUPERVISED, EVEN IF NOT RUNNING, MAKE CERTAIN THAT THE ELECTRICAL AND HYDRAULIC
POWER SUPPLIES ARE COMPLETELY DISCONNECTED. THEREFORE, IN SUCH CASES:
• TRIP THE DIFFERENTIAL CIRCUIT BREAKER TO DISCONNECT THE ELECTRIC POWER SUPPLY TO THE
HIGH PRESSURE WASHER
• CLOSE THE STOPCOCK ON THE THE WATER SUPPLY HOSE TO DISCONNECT THE HYDRAULIC POWER
SUPPLY
L-LC216.02-BM
EN
IMPORTANT
WARNING
WARNING
WARNING
28 / 56