Steinbach The Gate Notice Originale page 19

11. The second person holds the shower head
tanks with the M6 Allen screws
5 6
12. Make sure that the vent valve
13. Slide the connecting elements
14. Screw the hose adapter
the main tank
5
The solar shower is assembled.
Filling the tank
To fill the tanks of your solar shower, proceed as follows:
1. Connect a garden hose to the hose adapter
garden hose in such a way that nobody can trip over it.
2. Slide the connecting element between the
additional tank and the shower head upward.
Unscrew the vent valve
tank so that air can escape from the tank.
6
3. Turn on the water supply faucet. Turn the
faucet all the way to the "hot" position and
4
open it. In this position, the tank fills fastest.
Water flows into the tank. It takes approx. 5
minutes for the tanks to fill.
4. As soon as water runs steadily out of the
connection for the vent valve, screw the vent
valve into the addition tank.
5. As soon as water runs uniformly out of the
shower head
1
6. Turn off the faucet of the water pipe.
The tank is filled.
Operation
Using the solar shower
Observe the following before using your solar shower:
- Bacteria can multiply in warm water if the product is not used for longer periods. Risk of infection!
The tank must be drained.
- The water temperature in the tank depends on the level of sunshine. In cloudy weather, the water
will take longer to heat up. The water can become very hot in the case of intense sunlight.
- Remove obstacles from the showering area.
To use your filled solar shower, proceed as follows:
1. Connect a garden hose to the hose adapter
garden hose so that no one can trip over it. Turn on the water supply faucet.
2. Turn the faucet
3. Turn the faucet left or right to set your desired water temperature. Use the faucet to control the
water temperature and quantity, and enjoy showering in warm water.
4. After showering, close the shower faucet. Turn off the faucet of the water pipe.
The shower is finished.
Sometimes a little water runs out of the shower head, even if the faucet is shut. This is
due to the heating of warm water in the depressurized tank and is not a defect.
is screwed into the additional tank
2
onto the tanks.
3
or the inlet valve
15
.
from the additional
2
, close the faucet.
to the center position (between hot and cold). Open the shower faucet.
4
while you screw the shower head onto the two
1
.
11
onto the hose connection and the drain cap
14
and the faucet of the water pipe. Position the
15
7
and the faucet of the water pipe. Position the
15
.
6
2
6
into
13
19