Ilustrated Description - stayer ROSE550 Instructions D'emploi

gb
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and unplugged before carrying
out any work on the tool.
- The machine is assembled.
Engage the extension cord
CAUTION: Make sure that the extension cord
is unplugged to the mains outletd.
When connecting the extension cord, the cord of the
machine use the hook 4 to secure the cable and avoid
disconnections and possible cable cuts by the same
machine.
Always watch where the wire.

ILUSTRATED DESCRIPTION

1 Start switch.
2 Safety switch.
3 Hand guard.
4 Hook.
5 Blade.
6 Side cover.
7 Blade Guard.
8 Hand guard screws.
9 Set screws fastening blades.
10 Main handle.
3_OPERATING INSTRUCTIONS
START
For safety reasons the machine does not work
if the two hands are not in a safe position.
To start the machine with one hand push the safety
switch 2, while the other presses the start switch 1.
Keep blades lubricated for best cut. See
instructions on maintenance.
CAMBIO DE HERRAMIENTAS
Only a correct insertion of the blades is guaranteed to
work well and that the aforementioned safety position
is effective. This is why the blade change must also be
carried out in a workshop STAYER.
Sharpening of blade
The blades can only be sharpened by opening the
device and intervening in the safety configuration.
Only allow the blades to be sharpened by a specialist
workshop authorized by STAYER.
Storage
Put the blade cover on the shear blades 7 so that the
blades are not exposed. Store the tool out of the reach
of children carefully.
The blades can only be sharpened by
opening the device and intervening in the
safety configuration. Only allow the blades to
be sharpened by a specialist workshop
authorized by STAYER.
Do not cut dead trees or similar hard objects.
Doing so may damage the tool.
In order to uniformly cut the top of a hedge,
it is helpful to attach a bead to the desired
height of the hedge and cut along it, using it
as a reference. (Fig.7).
To cut the side of a hedge uniformly, it is
useful to cut from the bottom up. (Fig.8).
Cut boxwood or rhododendron wood from
the base to the top for an attractive look and
a good job. (Fig.9)
As a basic operation, tilt the blades in the
cutting direction and move the hedge clip
quietly and gently at a speed of 3 - seconds
per meter.
4_MAINTENANCE AND SERVICE
INSTRUCTIONS
CLEANING
Maintenance
CAUTION: Always be sure that the tool is
switched
attempting
maintenance.
Cleaning the tool
Clean out the tool by wiping off dust with a dry or
soapdipped rag.
CAUTION: Do not use gasoline , thinner,
benzine or heating oil etc.
Blade maintenance
Smear the blade 5 before and once per hour during
operation using machine oil or similars.
After operation, remove dust from both sides of the
blade 5 with wired brush, wipe off it with a rag and
then apply enough low-viscosity oil, such as machine
oil etc. and spray-type lubricating oil.
CAUTION: Do not wash the blades in water.
Failure to do so may cause rust or damage
on the tool.
REPAIR SERVICE
Our after-sales service responds to your questions
conceming maintenance and repair ofyour product as
well as spare parts.
Exploded views and information on spare parts can
also be found under: info@grupostayer.com
/ /
14
off and unplugged
to perform inspection
before
or