Haier HRH-60 Mode D'emploi page 14

English
The user instructions apply to several models, for
this reason there may be some differences
the details given, according to the type of the appliance..
1 Protecting the environment / advice for disposal
Packing
serves to protect the appliance during transportation and
recyclable materials have been used for packaging.
Corrugated board/cardboard (mainly from waste paper).
- shaped parts in PS (foamed CFC- free polystyrene)
- foils and bags in PE (polyethylene)
- strapping tapes in PP (polypropylene)
- Please hand over all packaging to the nearest official
collection point, so that all the different materials can
be re-used or recycled as far as possible and
any illegal depositing of such materials is thus avoided
2 Deciding where to locate your appliance
In order to avoid any damage or injury to
persons or things, the appliance should be unpacked
by two people and placed in the chosen location
Before positioning it, check that your new appliance
has no visible outer damage.
On no account should you start up your appliance if it is
damaged. Check the appliance carefully for:
■ Damage to the packaging which might indicate that
appliance has been mishandled during transportation
■ Damage to the outer casing
■ Any visible damage to the cable / plug
let
If in any doubt
department
check the appliance.
It must at all costs be avoided, that any environmentally
damaging refrigerant leaks out by starting up the
appliance.
3 Installing your appliance
a) Unpack the fridge / freezer.
b) In order not to unnecessarily waste raw materials, the
handles (requiring smaller packaging)
been mounted onto the separate parts of
appliance.Mount the
same time anyother enclosed
to the relevant instructions enclosed separately.
c) Remove any objects from inside the appliance
d) Carefully remove all film and adhesive tape from the
casing from the door
e) Remove any polystyrene
around the compressor (if present).
f) Remove all documents
inside the appliance.
g) Clean the inside
lukewarm water and
thoroughly with a soft cloth.
All manuals and user guides at all-guides.com
in
the customer service
have not
the
door handles and at the
parts according
pieces from
and accessories from
of the appliance with
vinegar and dry it
Instruction for use
Do not use washing
abrasive household
cleaning agents containing soda.
■ Make sure that the pipes for the circulation of the
refrigerant are not damaged in any way during
installation of the appliance.
■ The appliance must only be used for the purpose
for which it is intended.
■ The appliance. must
level surface. This is the only way to
that the refrigerant
ensure that your appliance will work effciently.
■ If possible, place
well aired, dry room.
■ Do not place your appliance in direct sunlight, nor in a
room at high temperature.
■ Do not place your
of any sources of direct heat such as heating, ovens,
cooking stove etc.
compressor would have
a result the
considerably higher).
If installation near
cannot be avoided, we recommend fitting a
suitable insulation plate between the appliance and
the heat source (do not use asbestos), or at least
the following minimum distances must be observed:
■ from a gas or electric cooker
■ from a radiator or oven etc
■ from another refrigerating appliance
Do not place any appliances, such as microwaves,
toasters etc. which give off heat on the
appliance
Never obstruct the ventilation grille.
Always pull out the plug itself and never pull the
cable when cutting the appliance off from the mains
supply.
WARNING !
Leave the appliance standing in its final position for
at least 2 hours before switching it on, so that the
circulation of the
no
operating problems occur.
Before connecting up the appliance, make sure that it
is absolutely dry inside - especially in the corners..
Danger warnings
Depending on its composition, the
be easily inflammable.
has been hermetically sealed
many times for possible leaks. Any inexpert interference
might well create a fire hazard.
mechanically effects the circulation of the refrigerant,
nor, in particular, the
compressor..
Only expert professional personnel should intervene
on the refrigerating system.
2
Refrigerator
liquids, sharp
products or any
be placed on a
can circulate freely and thus
your appliance in a cool,
appliance in the
(This would mean
to work harder and
power consumption would be
a direct heat source
30cm
30 cm
30 cm
refrigerant stabilises
refrigerant can
The refrigerant
and has been
Make sure nothing
accessible parts around the
or
other
firm,
ensure
vicinity
the
as
.
and
circuit
tested