Cover Plate - Makita JV101D Manuel D'instruction

To install, insert the rip fence into the rectangular hole
on the side of the base with the fence guide facing
down. Slide the rip fence to the desired cutting width
position, then tighten the bolt to secure it.
1
2
► 1. Hex wrench 2. Bolt 3. Fence guide 4. Rip fence
(Guide rule)
Circular cuts
When cutting circles or arcs of 170 mm or less in radius,
install the rip fence as follows.
1
► 1. Rip fence (Guide rule)
1. Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
2.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded knob
onto the pin to secure the pin.
3
2
► 1. Threaded knob 2. Fence guide 3. Rip fence
(Guide rule) 4. Pin
3.
and tighten the bolt to secure it in place. Then move the
base all the way forward.
NOTE: Always use jig saw blades No. B-17, B-18,
B-26 or B-27 when cutting circles or arcs.
Anti-splintering device
Optional accessory, only for aluminum base model
be used when making bevel cuts.
3
4
► 1. Base 2. Anti-splintering device
For splinter-free cuts, the anti-splintering device can
be used. To install the anti-splintering device, move the
tool base all the way forward and fit it from the back of
tool base.
When you use the cover plate, install the anti-splintering
device onto the cover plate.

Cover plate

Optional accessory, only for aluminum base model
► 1. Cover plate 2. Base
Use the cover plate when cutting decorative veneers,
1
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
4
10 ENGLISH
Slide the rip fence to the desired cutting radius,
CAUTION:
The anti-splintering device cannot
1
2
1
2